Premium Quality!
Thermoplastic Lines
Preformed Thermoplastic Line Marking Tape: Quick, Professional, and Built to Last
Preformed Thermoplastic Line Marking is one of the easiest and most reliable ways to put down permanent markings. Each roll is ready to use and installs quickly with a propane torch, no paint, no drying time, no mess. It’s widely used for car parks, school zones, warehouses, cycle paths and busy roads where a fast and durable solution is needed.
At Thermoplastic Line Markings, we’re one of the UK’s largest companies offering thermoplastic products. We now make these available for everyone, from private customers to national contractors, to order directly from us.
You can buy our thermoplastic line marking supplies on our website, but if you’d like advice or need help choosing the right product, call our head UK head office team at Thermoplastic Line Markings on 01539 292890
High Quality!
Cost Effective!
Fast Delivery!
Why choose preformed thermoplastic rolls
- Fast to install, roll out, heat with a torch, and it bonds straight to the surface
- Long-lasting, certified to BASt P7, tested to over 4 million wheel-overs
- Safe and visible, reflective, skid-resistant, compliant with BS EN 1790, BS EN 1436, BS EN 1871, AASHTO and FHWA
- Works on most surfaces, ideal for tarmac, suitable for concrete or block paving with a primer
Our Thermoplastics delivered from us to you in whichever colour you desire!
Supplied in White and yellow!
Sizes and colours
Roll length: 5 metres
Widths: 50mm and 100mm (most common for bays, double yellows and junctions)
Colours: White or Yellow
Where it’s used
- Car parks and school drop-off zones
- Warehouse lanes and factory floors
- Footpaths, playgrounds and cycle lanes
- Road junctions, crossings and TSRGD layouts
The textured finish improves grip and visibility, even in wet or high-traffic conditions.
Performance and standards
- Roll length: 5m
- Widths: 50mm and 100mm
- Colours: white and yellow
- Meets BS EN 1790, BS EN 1436, BS EN 1871, AASHTO and FHWA
- BASt certification P7 (tested to 4 million wheel-overs)
- Retroreflectivity, luminance and skid resistance tested to international standards
Application of thermoplastics!
How to apply
- Clean the surface of dust, oil or debris. Use primer on concrete, block paving or older surfaces.
- Warm the area with a torch to remove moisture.
- Place the tape glass-bead side up and cut to size if needed.
- Heat evenly from 20–40 cm away using a sweeping motion. The tape softens, bubbles slightly and flows into the surface.
- Allow 5–10 minutes to cool and harden, then check adhesion. If it lifts, reheat.
Preformed thermoplastic roll. Cold weather tip: store rolls in a warm
place and pre-warm before unwrapping. Cold thermoplastic can become
brittle; warming helps keep it flexible.
